H3C Technologies H3C S7500E Series Switches - Manual (Page 172)

4-12
For configurations in VPLS address family view, see MPLS L3VPN Configuration in the MPLS
Configuration Guide .
Enabling MPLS L2VPN
You need to enable MPLS L2VPN before you can configure VPLS related configurations.
Follow these steps to enable MPLS L2VPN:
To do… Use the command… Remarks
Enter system view system-view —
Configure the reserve VLAN for
MPLS L2VPN
mpls l2vpn reserve vlan vlan-id
Optional
If the SRPU is LSQ1SRP1CB, you
can enable MPLS L2VPN only
after you configure the mpls l2vpn
reserve vlan command.
Enable MPLS L2VPN mpls l2vpn Required
For detailed information about the mpls l2vpn command, see MPLS L2VPN Commands in the MPLS
Command Reference .
Configuring a BGP VPLS Instance
When creating a BGP VPLS instance, you must specify a globally unique name for the VPLS instance
and set the peer discovery mechanism to automatic configuration.
When configuring a BGP VPLS instance, you must configure BGP as the signaling protocol to be
used.
Follow these steps to configure a BGP VPLS instance:
To do… Use the command… Remarks
Enter system view system-view —
Create a BGP VPLS instance and
enter VSI view
vsi vsi-name auto Required