H3C Technologies H3C S7500E Series Switches - Manual (Page 104)

3-22
To do… Use the command... Remarks
Enter system view system-view ––
Enter MPLS view mpls ––
Enable RSVP-TE on your device mpls rsvp-te
Required
Disabled by default
Exit to system view quit ––
Enter interface view of MPLS TE
link
interface interface-type
interface-number
––
Enable RSVP-TE on the interface mpls rsvp-te
Required
Disabled by default
Enter MPLS TE tunnel interface
view
interface tunnel tunnel-number ––
Set the signaling protocol for
setting up the MPLS TE tunnel to
RSVP-TE
mpls te signal-protocol rsvp-te
Optional
RSVP-TE applies by default.
Submit current tunnel
configuration
mpls te commit Required
To use RSVP-TE as the signaling protocol for setting up the MPLS TE tunnel, you must enable both
MPLS TE and RSVP-TE on the interface for the tunnel to use.
Configuring RSVP-TE Advanced Features
RSVP-TE adds new objects in Path and Resv messages to support CR-LSP setup. RSVP-TE
provides many configurable options with respect to reliability, network resources, and other advanced
features of MPLS TE.
Before performing the configuration tasks in this section, be aware of each configuration objective and
its impact on your network.
Configuration Prerequisites
Before configuring RSVP-TE advanced features, do the following:
z
Configure MPLS basic capabilities
z
Configure MPLS TE basic capabilities
z
Establish an MPLS TE tunnel with RSVP-TE