H3C Technologies H3C S7500E Series Switches - Manual (Page 113)

3-31
To do… Use the command... Remarks
Enter system view system-view ––
Enter MPLS TE tunnel interface
view
interface tunnel tunnel-number ––
Configure maximum number of
tunnel setup retries
mpls te retry times
Optional
The default is 5.
Configure the tunnel setup retry
interval
mpls te timer retry seconds
Optional
The default is 2 seconds.
Submit current tunnel
configuration
mpls te commit Required
Assigning priorities to a tunnel
Two priorities, setup priority and holding priority, are assigned to paths for MPLS TE to make
preemption decision. For a new path to preempt an existing path, the setup priority of the new path
must be greater than the holding priority of the existing path.
To avoid flapping caused by improper preemptions between CR-LSPs, the setup priority of a CR-LSP
should not be set higher than its holding priority.
Follow these steps to assign priorities to a tunnel:
To do… Use the command... Remarks
Enter system view system-view ––
Enter MPLS TE tunnel interface
view
interface tunnel tunnel-number ––
Assign priorities to the tunnel
mpls te priority setup-priority
[ hold-priority ]
Optional
The default setup and holding
priorities are 7.
Submit current tunnel
configuration
mpls te commit Required
Configuring Traffic Forwarding
Configuration Prerequisites
Before configuring traffic forwarding, do the following:
z
Configure MPLS basic capabilities
z
Configure MPLS TE basic capabilities
z
Configure MPLS TE tunnels