H3C Technologies H3C S7500E Series Switches - Manual (Page 222)

5-30
Example for Configuring MPLS L2VPN Connection for a Service Instance
Netowrk requirments
z
CE 1 and CE 2 are connected to PE 1 and PE 2 respectively through VLAN interfaces.
z
On PE 1 and PE 2, create MPLS L2VPN connections for CE 1 and CE 2 in service instance view.
Figure 5-7 Network diagram for configuring MPLS L2VPN connections on service instances
PE1
Loop0
P
Loop0
PE2
Loop0
GE2/0/1
Vlan-int23
Vlan-int23
Vlan-int10
Vlan-int26
Vlan-int26 GE2/0/1
Martini
Vlan-int10
CE1 CE2
Device Interface IP address Device Interface IP address
CE 1 Vlan-int10 100.1.1.1/24 P Loop0 192.4.4.4/32
PE 1 Loop0 192.2.2.2/32 Vlan-int23 23.1.1.2/24
Vlan-int23 23.1.1.1/24 Vlan-int26 26.2.2.2/24
CE 2 Vlan-int10 100.1.1.2/24 PE 2 Loop0 192.3.3.3/32
Vlan-int26 26.2.2.1/24
Configuration procedure
1) Configure CE 1
system-view
[Sysname] sysname CE1
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
2) Configure PE 1
system-view
[Sysname] sysname PE1
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
# Configure the LSR ID and enable MPLS globally.
[PE1] mpls lsr-id 192.2.2.2
[PE1] mpls
[PE1-mpls] quit
# Enable MPLS L2VPN and LDP globally.
[PE1] mpls l2vpn
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure PE 1 to establish an LDP remote session with PE 2.
[PE1] mpls ldp remote-peer 1
[PE1-mpls-ldp-remote-1] remote-ip 192.3.3.3
[PE1-mpls-ldp-remote-1] quit
# Configure the interface connected with the P device and enable LDP on the interface.