Configuration procedure – H3C Technologies H3C S7500E Series Switches User Manual

Page 187

4-27

Figure 4-9

Network diagram for configuring BFD in an H-VPLS network for main link detection

Configuration procedure

1) Configure MPLS basic capabilities

# Configure Switch A.

system-view

[SwitchA] mpls lsr-id 1.1.1.9

[SwitchA] mpls

[SwitchA-mpls] quit

[SwitchA] mpls ldp

[SwitchA-mpls-ldp] quit

[SwitchA] mpls ldp remote-peer switchb

[SwitchA-mpls-ldp-remote-switchb] remote-ip 2.2.2.9

[SwitchA-mpls-ldp-remote-switchb] remote-ip bfd

[SwitchA-mpls-ldp-remote-switchb] quit

[SwitchA] mpls ldp remote-peer switchc

[SwitchA-mpls-ldp-remote-switchc] remote-ip 3.3.3.9

[SwitchA-mpls-ldp-remote-switchc] remote-ip bfd

[SwitchA-mpls-ldp-remote-switchc] quit

[SwitchA] vlan 12

[SwitchA-vlan12] port gigabitethernet 2/0/2

[SwitchA-vlan12] quit

[SwitchA] vlan 13

[SwitchA-vlan13] port gigabitethernet 2/0/1

[SwitchA-vlan13] quit

[SwitchA] interface vlan-interface 12

[SwitchA-Vlan-interface12] mpls

[SwitchA-Vlan-interface12] mpls ldp

[SwitchA-Vlan-interface12] quit

[SwitchA] interface vlan-interface 13

[SwitchA-Vlan-interface13] mpls

[SwitchA-Vlan-interface13] mpls ldp

[SwitchA-Vlan-interface13] quit

# Configure Switch B.

system-view

[SwitchB] mpls lsr-id 2.2.2.9