H3C Technologies H3C S7500E Series Switches - Manual (Page 254)

6-29
To do… Use the command… Remarks
ip route-static dest-address
{ mask | mask-length }
{ gateway-address | interface-type
interface-number
[ gateway-address ] |
vpn-instance
d-vpn-instance-name
gateway-address } [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
Configure static routes for a
specified VPN instance
ip route-static vpn-instance
s-vpn-instance-name &<1-5>
dest-address { mask |
mask-length } { gateway-address
[ public ] | interface-type
interface-number
[ gateway-address ] |
vpn-instance
d-vpn-instance-name
gateway-address } [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
Required
z
Perform this configuration on the PEs. The configuration method on the CEs is the same for
configuring ordinary static routes.
z
For information about static route, see Static Routing Configuration in the Layer 3 - IP Routing
Configuration Guide .
Configuring RIP between PE and CE
A RIP process belongs to only one VPN instance. If you run a RIP process without binding it to a VPN
instance, the process is considered a public network process.
Follow these steps to configure RIP between PE and CE:
To do… Use the command… Remarks
Enter system view system-view —
Create a RIP instance between PE
and CE and enter RIP view
rip [ process-id ] vpn-instance
vpn-instance-name
Required