H3C Technologies H3C S7500E Series Switches - Manual (Page 107)

3-25
To do… Use the command... Remarks
Enter system view system-view ––
Enter MPLS view mpls ––
Enable global RSVP hello
extension
mpls rsvp-te hello
Required
Disabled by default
Configure the maximum number of
consecutive hellos that should be
lost before the link is considered
failed.
mpls rsvp-te hello-lost times
Optional
By default, the link is considered
failed if three consecutive hellos
are lost.
Configure the hello interval
mpls rsvp-te timer hello
timevalue
Optional
The default is 3 seconds.
Exit to system view quit ––
Enter interface view of MPLS TE
link
interface interface-type
interface-number
––
Enable interface RSVP hello
extension
mpls rsvp-te hello
Required
Disabled by default
RSVP hello extension detects the reachability of RSVP neighboring nodes. It is defined in RFC 3209.
Configuring RSVP-TE resource reservation confirmation
Follow these steps to configure RSVP-TE resource reservation confirmation:
To do… Use the command... Remarks
Enter system view system-view ––
Enter MPLS view mpls ––
Enable resource reservation
confirmation
mpls rsvp-te resvconfirm
Required
Disabled by default