H3C Technologies H3C S7500E Series Switches - Manual (Page 174)

4-14
Configuring VPLS Instance Attributes
Follow these steps to configure other VPLS attributes:
To do… Use the command… Remarks
Enter system view system-view —
Enter VSI view vsi vsi-name —
Specify the encapsulation type of
the VPLS instance
encapsulation { bgp-vpls |
ethernet | vlan }
Optional
vlan by default, which
corresponds to the VSI PW
encapsulation type of tagged.
Set the description of the VPLS
instance
description text
Optional
No description set by default
Shut down the VPLS service of the
VPLS instance
shutdown
Optional
Enabled by default
Specify a tunneling policy for the
VPLS instance
tnl-policy tunnel-policy-name
Optional
By default, a VPLS instance uses
the default tunneling policy.
Displaying and Maintaining VPLS
Displaying and maintaining VPLS
To do… Use the command… Remarks
Display the VPLS information in
the BGP routing table
display bgp vpls { all | group
[ group-name ] | peer
[ [ ip-address ] verbose ] |
route-distinguisher
route-distinguisher [ site-id site-id
[ label-offset label-offset ] ] }
Available in any view
Display the MAC address table
information of one or all VPLS
instances
display mac-address vsi
[ vsi-name ] [ blackhole | dynamic
| static ] [ count ]
Available in any view
Display information about VPLS
connections
display vpls connection [ bgp |
ldp | vsi vsi-name ] [ block | down
| up ] [ verbose ]
Available in any view
Display the FIB information of one
or all VPLS instances (on a
distributed device)
display vpls fib [ vsi vsi-name
[ link link-id ] ] [ slot slot-id ]
[ verbose ]
Available in any view