H3C Technologies H3C S7500E Series Switches - Manual (Page 169)

4-9
z
Configure LDP remote peers on PEs to establish remote LDP sessions. For configuration
information, see MPLS Basics Configuration in the MPLS Configuration Guide.
Enabling MPLS L2VPN
You need to enable MPLS L2VPN before you can perform VPLS related configurations.
Follow these steps to enable MPLS L2VPN:
To do… Use the command… Remarks
Enter system view system-view —
Configure the reserve VLAN for
MPLS L2VPN
mpls l2vpn reserve vlan vlan-id
Optional
If the SRPU is LSQ1SRP1CB, you
can enable MPLS L2VPN only
after you configure the mpls l2vpn
reserve vlan command.
Enable MPLS L2VPN mpls l2vpn Required
For detailed information about the mpls l2vpn command, see MPLS L2VPN Commands in the MPLS
Command Reference .
Configuring an LDP VPLS Instance
When creating an LDP VPLS instance, you need to perform the following configurations:
1) Specify a globally unique name for the VPLS instance and set the peer discovery mechanism to
manual configuration.
2) Configure LDP as the signaling protocol to be used.
3) Specify the ID of the VPLS instance.
4) Use the peer command to create the VPLS peer PE for the instance, specifying:
z
IP address of the peer PE.
z
ID of the PW to the peer PE, which must be consistent with that specified on the peer PE.
z
Type of the peer PE. A peer of the UPE type is a user access convergence device in the H-VPLS
model. For a UPE, you can configure one and only one NPE peer as the backup peer of the UPE.
z
PW class template to be referenced. A PW class template defines the PW transport mode and
tunneling policy to be used.
Follow these steps to configure an LDP VPLS instance:
To do… Use the command… Remarks
Enter system view system-view —