H3C Technologies H3C S7500E Series Switches - Manual (Page 175)

4-15
To do… Use the command… Remarks
Display the FIB information of one
or all VPLS instances (on a
distributed IRF device)
display vpls fib [ vsi vsi-name
[ link link-id ] ] [ chassis
chassis-number slot slot-id ]
[ verbose ]
Available in any view
Display information about one or
all VPLS instances
display vsi [ vsi-name ]
[ verbose ]
Available in any view
Display information about remote
VPLS connections
display vsi remote { bgp | ldp } Available in any view
Display information about one or
all PW class templates
display pw-class
[ pw-class-name ]
Available in any view
Clear the MAC address table of
one or all VPLS instances
reset mac-address vsi
[ vsi-name ]
Available in user view
Resetting VPLS
To do… Use the command… Remarks
Reset a specified or all VPLS BGP
connections
reset bgp vpls { as-number |
ip-address | all | external |
internal }
Available in user view
VPLS Configuration Examples
Configuring VPLS Instance
Network requirements
z
CE 1 and CE 2 are connected to PE 1 and PE 2 respectively through VLANs.
z
Configure VPLS instance aaa to use LDP (Martini mode) and VPLS instance bbb to use BGP
(Kompella mode), and configure the AS number as 100.
z
On PE 1 and PE 2: Configure service instance 1000 to match packets that are received on
GigabitEthernet 2/0/1 and carry the VLAN tag of 100 and specify to forward them through VPLS
instance aaa. Configure service instance 2000 to match packets that are received on
GigabitEthernet 2/0/1 and carry VLAN tag of 200 and specify to forward them through VPLS
instance bbb.