H3C Technologies H3C S7500E Series Switches - Manual (Page 199)

5-7
Configuring CCC MPLS L2VPN
Configuration Prerequisites
Before configuring CCC L2VPN, complete these tasks:
z
Configuring MPLS basic capability for the MPLS backbone on the PEs and P devices.
z
Enabling MPLS L2VPN on PEs of the MPLS backbone. You do not need to enable MPLS L2VPN
on the P devices.
To configure CCC MPLS L2VPN, you need the following data:
z
Name for the CCC connection
z
Connection type: local or remote
z
For a local CCC connection: the types and numbers of the incoming and outgoing interfaces
z
For a remote CCC connection: the type and number of the incoming interface, the address of the
next hop or the type and number of the outgoing interface, and the incoming and outgoing labels
of the LSRs along the CCC connection
Configuration Procedure
Configuring the remote CCC connection
1) Configure the PEs
Follow these steps to configure a PE:
To do… Use the command… Remarks
Enter system view system-view —
Create a remote CCC connection
between CEs connected to
different PEs
ccc ccc-connection-name
interface interface-type
interface-number in-label
in-label-value out-label
out-label-value nexthop
ip-address [ control-word |
no-control-word ]
Required
You do not need to configure two static LSPs for each remote CCC connection. Instead, you only
need to configure the incoming and outgoing labels, where the incoming label must be exclusively for
the CCC connection. The labels function as static LSPs.
2) Configure the P devices
Follow these steps to configure a P device: