H3C Technologies H3C S7500E Series Switches - Manual (Page 171)

4-11
To do… Use the command… Remarks
Enter system view system-view —
Enter the view of the interface
connecting a CE
interface interface-type
interface-number
—
Create a service instance and
enter its view
service-instance
service-instance-id
Required
By default, no service instance is
created.
Configure a packet matching rule
for the service instance
encapsulation s-vid vlan-id
Required
By default, no packet matching
rule is configured for a service
instance..
Associate the service instance with
a VPLS instance
xconnect vsi vsi-name
[ access-mode { ethernet |
vlan } ]
Required
By default, a service instance is
not associated with any VPLS
instance.
Configuring BGP VPLS
Configuration Prerequisites
z
Configure IGP on the MPLS backbone devices (PEs and P devices) to guarantee the IP
connectivity of the MPLS backbone. For configuration details, see Layer 3 - IP Routing
Configuration Guide .
z
Configure MPLS basic capability on the MPLS backbone devices (PEs and P devices) to
establish LSP tunnels on the backbone network. For configuration information, see MPLS Basics
Configuration in the MPLS Configuration Guide.
Configuring the BGP Extension
Before configuring BGP VPLS, you need to configure BGP parameters on the PEs. For configuration
details, see BGP Configuration in the Layer 3 - IP Routing Configuration Guide.
Follow these steps to configure BGP extension:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter VPLS address family view vpls-family Required
Activate a peer peer peer-address enable
Required
No peer is activated by default.