H3C Technologies H3C S7500E Series Switches - Manual (Page 116)

3-34
To do… Use the command... Remarks
Enable IGP to advertise the route
of the MPLS TE tunnel to IGP
neighbors.
mpls te igp advertise [ hold-time
value ]
Required
Routes of MPLS TE tunnels are
not advertised to IGP neighbors by
default.
Assign a metric to the MPLS TE
tunnel
mpls te igp metric { absolute |
relative } value
Optional
The metrics of TE tunnels equal
the metrics of their corresponding
IGP routes by default.
Submit current tunnel
configuration
mpls te commit Required
Exit to system view quit ––
Enter OSPF view ospf [ process-id ] ––
Enable forwarding adjacency
enable traffic-adjustment
advertise
Required
Disabled by default
If you use automatic route advertisement, it is required to specify the destination address of the TE
tunnel as the LSR ID of the peer.
Configuring Traffic Forwarding Tuning Parameters
In MPLS TE, you may configure traffic forwarding tuning parameters such as the failed link timer and
flooding thresholds to change paths that IP or MPLS traffic flows traverse or to define type of traffic
that may travel down a TE tunnel.
Configuration Prerequisites
The configurations described in this section are used in conjunction with CSPF and the dynamic
signaling protocol RSVP-TE.
Configuration Procedure
Configuring traffic forwarding tuning parameters involves these tasks:
z
Configuring the failed link timer
z
Configuring the link metric used for routing a tunnel
z
Configuring the traffic flow type of a tunnel