beautypg.com

Configuration prerequisites, Configuration procedure, Configuring basic mpls l3vpn – H3C Technologies H3C S7500E Series Switches User Manual

Page 252

background image

6-27

Configuration Prerequisites

Before configuring an LDP instance, be sure to complete these tasks:

z

Configuring a VPN instance

z

Configuring MPLS basic capability

z

Configuring MPLS LDP capability

Configuration Procedure

Follow these steps to configure an LDP instance:

To do…

Use the command…

Remarks

Enter system view

system-view

Enable LDP capability for a VPN

instance and enter MPLS LDP

VPN instance view

mpls ldp

vpn-instance

vpn-instance-name

Required

Not enabled by default

Configure the LDP parameters

except LDP GR for the VPN

instance

See MPLS Basics Configuration in

the MPLS Configuration Guide for

the detailed configuration.

Optional

z

Except the command for LDP GR, all commands available in MPLS LDP view can be configured
in MPLS LDP VPN instance view. For detailed information about MPLS LDP, see MPLS Basics

Configuration

in the MPLS Configuration Guide.

z

Configurations in MPLS LDP VPN instance view affect only the LDP-enabled interface bound to
the VPN instance, while configurations in MPLS LDP view do not affect interfaces bound to VPN
instances. When configuring the transport address of an LDP instance, you need to use the IP
address of the interface bound to the VPN instance.

z

By default, LDP adjacencies on a private network are established using addresses of the
LDP-enabled interfaces, while those on the public network are established using the LDP LSR ID.

Configuring Basic MPLS L3VPN

This section describes how to configure a simple MPLS L3VPN, where only one carrier is involved, the
MPLS backbone is not inter-provider, and none of the PEs or CEs functions as a PE and a CE at the
same time.

Some special MPLS L3VPN networking scenarios such as HoVPN, multi-role host, and inter-provider
VPN require additional configurations. For more information, refer to the related sections in this
chapter.

In configuring MPLS L3VPN, the key task is to manage the advertisement of VPN routes on the MPLS
backbone and includes the management of route advertisement between PEs and CEs and that
between PEs.