H3C Technologies H3C S7500E Series Switches - Manual (Page 289)

6-64
6) Verify your configurations
After you complete the above configurations, the CEs should be able to learn the interface routes from
each other and ping each other.
Example for Configuring Inter-Provider VPN Option B
Network requirements
z
Site 1 and Site 2 belong to the same VPN. CE 1 of Site 1 accesses the network through PE 1 in
AS 100 and CE 2 of Site 2 accesses the network through PE 2 in AS 600.
z
PEs in the same AS runs IS-IS between them.
z
PE 1 and ASBR-PE 1 exchange labeled IPv4 routes by MP-IBGP.
z
PE 2 and ASBR-PE 2 exchange labeled IPv4 routes by MP-IBGP.
z
ASBR-PE 1 and ASBR-PE 2 exchange labeled VPN-IPv4 routes by MP-EBGP.
z
ASBRs do not perform VPN target filtering of received VPN-IPv4 routes.
Figure 6-21 Configure inter-provider VPN option B (on switches)
Loop0 Loop0
Loop0 Loop0
CE 1 CE 2
AS 65001 AS 65002
PE 1 PE 2
ASBR-PE 2 ASBR-PE 1
MPLS backbone MPLS backbone
AS 100 AS 600
Vlan-int11 Vlan-int11
Vlan-int12
Vlan-int12
Vlan-int13 Vlan-int13
Vlan-int12
Vlan-int12
Site 1 Site 2
Device Interface IP address Device Interface IP address
PE 1 Loop0 2.2.2.9/32 PE 2 Loop0 5.5.5.9/32
Vlan-int11 30.0.0.1/8 Vlan-int11 20.0.0.1/8
Vlan-int12 1.1.1.2/8 Vlan-int12 9.1.1.2/8
ASBR-PE 1 Loop0 3.3.3.9/32 ASBR-PE 2 Loop0 4.4.4.9/32
Vlan-int12 1.1.1.1/8 Vlan-int12 9.1.1.1/8
Vlan-int13 11.0.0.2/8 Vlan-int13 11.0.0.1/8
Configuration procedure
1) Configure PE 1
# Run IS-IS on PE 1.
system-view
[PE1] isis 1
[PE1-isis-1] network-entity 10.111.111.111.111.00
[PE1-isis-1] quit
# Configure LSR ID, enable MPLS and LDP.