H3C Technologies H3C S7500E Series Switches - Manual (Page 284)

6-59
0.00% packet loss
round-trip min/avg/max = 34/48/72 ms
[CE1] ping 10.4.1.1
PING 10.4.1.1: 56 data bytes, press CTRL_C to break
Request time out
Request time out
Request time out
Request time out
Request time out
--- 10.4.1.1 ping statistics ---
5 packet(s) transmitted
0 packet(s) received
100.00% packet loss
Example for Configuring Inter-Provider VPN Option A
Network requirements
z
CE 1 and CE 2 belong to the same VPN. CE 1 accesses the network through PE 1 in AS 100 and
CE 2 accesses the network through PE 2 in AS 200.
z
Inter-provider MPLS L3VPN is implemented using option A. That is, the VRF-to-VRF method is
used to manage VPN routes.
z
The MPLS backbone in each AS runs OSPF.
Figure 6-20 Configure inter-provider VPN option A
Loop0 Loop0
Loop0 Loop0
Vlan-int11
CE 1 CE 2
AS 65001 AS 65002
PE 1 PE 2
ASBR-PE 2 ASBR-PE 1
MPLS backbone MPLS backbone
AS 100 AS 200
Vlan-int11 Vlan-int11
Vlan-int11
Vlan-int12
Vlan-int12
Vlan-int13 Vlan-int13
Vlan-int12
Vlan-int12
Device Interface IP address Device Interface IP address
CE 1 Vlan-int11 10.1.1.1/24 CE 2 Vlan-int11 10.2.1.1/24
PE 1 Loop0 1.1.1.9/32 PE 2 Loop0 4.4.4.9/32
Vlan-int11 10.1.1.2/24 Vlan-int11 10.2.1.2/24
Vlan-int12 172.1.1.2/24 Vlan-int12 162.1.1.2/24
ASBR-PE 1 Loop0 2.2.2.9/32 ASBR-PE 2 Loop0 3.3.3.9/32
Vlan-int12 172.1.1.1/24 Vlan-int12 162.1.1.1/24
Vlan-int13 192.1.1.1/24 Vlan-int13 192.1.1.2/24
Configuration procedure
1) Configure IGP on the MPLS backbone, implementing the connectivity in the backbone