H3C Technologies H3C S7500E Series Switches - Manual (Page 23)

1-11
Configuring Route Exchange between a MCE and a Site
Configuring Route Exchange between a MCE and a Site
Complete the following tasks to configure route exchange between a MCE and a site:
Task Remarks
Configuring to Use Static Routes between a MCE and a Site
Configuring to Use RIP between a MCE and a Site
Configuring to Use OSPF between a MCE and a Site
Configuring to Use IS-IS between a MCE and a Site
Configuring to Use EBGP between a MCE and a Site
You can choose one or multiple
configurations as required.
Configuring to Use Static Routes between a MCE and a Site
Follow these steps to configure static routes between a MCE and a site:
To do… Use the command… Remarks
Enter system view system-view —
Define a static route for a
VPN instance
ip route-static vpn-instance
s-vpn-instance-name &<1-5> dest-address
{ mask | mask-length } { gateway-address
[ public ] | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address }
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
Required
This operation is performed
on the MCE device. The
corresponding configuration
on the site is the same as
configuring a normal static
route.
Configuring to Use RIP between a MCE and a Site
A RIP process can be bound to only one VPN instance. RIP processes not bound to any VPN
instances belong to the public network.
Follow these steps to configure RIP between a MCE and a site:
To do… Use the command… Remarks
Enter system view system-view —
Enable RIP for a VPN
instance (This operation
also leads you to RIP
view)
rip [ process-id ] vpn-instance
vpn-instance-name
Required
This operation is performed on the MCE
device. As for the corresponding
configuration on the site, you can just enable
RIP as usual.