H3C Technologies H3C S7500E Series Switches - Manual (Page 255)

6-30
:
z
Perform this configuration on the PEs. Only conventional RIP is required on CEs.
z
After configuring a RIP instance, you must start RIP by using the same method for starting a
common RIP process.
z
For description and detailed configuration about RIP, see RIP Configuration in the Layer 3 - IP
Routing Configuration Guide .
Configuring OSPF between PE and CE
An OSPF process that is bound to a VPN instance does not use the public network router ID
configured in system view. Therefore, you need to specify the router ID when starting a process or to
configure the IP address for at least one interface of the VPN instance.
An OSPF process belongs to only one VPN instance. If you run an OSPF process without binding it to
a VPN instance, the process is considered a public network process.
Follow these steps to configure OSPF between PE and CE:
To do… Use the command… Remarks
Enter system view system-view —
Create an OSPF instance between
PE and CE and enter the OSPF
view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ]
Required
Configure the OSPF domain ID
domain-id domain-id
[ secondary ]
Optional
0 by default
Configure the type codes of OSPF
extended community attributes
ext-community-type { domain-id
type-code1 | router-id type-code2
| route-type type-code3 }
Optional
The defaults are as follows:
0x0005 for Domain ID,
0x0107 for Router ID, and
0x0306 for Route Type.
Configure this command on a PE.
z
Perform the configurations on PEs. Only conventional OSPF is required on CEs.
z
Deleting a VPN instance will delete all related OSPF processes at the same time.
An OSPF process can be configured with only one domain ID. Domain IDs of different OSPF
processes are independent of each other.