Measurement Computing eZ-Analyst rev.14.1 - Manual (Page 81)

eZ-Analyst 978791 Edit Menu 4-45
Wave Tab
Wave Tab Selected
As seen in the preceding screen shot, several selections are available from within the Wave Tab. In the
above example [on the screen image], a sine wave has been modified with a 1.0 second amplitude Ramp-Up.
To add a Waveform Ramp Up or Ramp Down to a waveform:
1) select the appropriate button [Up or Dn]
2) from the ramp window click the Select [
Add Waveform Ramp Up ] checkbox (or press the spacebar)
3) enter the desired ramp time value (Note - this time is included in the Burst / Sweep On Time
If Burst mode or Swept Waveform mode is selected);
4) Click the window  [ OK ] button to accept the change, or the X button to cancel the operation.
Note: You can use the Tab key to cycle the selection highlight through all of the controls. You can
also use the Enter Key to select the  or X buttons.

How to modify the waveform Burst On/Sweep Time
This section discusses how to modify the waveform Burst
On/Sweep Time such that it will automatically track
changes to the Analyzer Frame Time when either the
Analysis Frequency or Spectral Line count change.
Click the Lock Icon on the configuration dialog. Then
check or uncheck the selection to lock waveform output to
the Frame Time. When waveform output is locked, the
Burst On / Sweep Time control is disabled, and the value
displayed is the Frame Time.
Ramp Up
Ramp Down
Select (
)
Cancel (X)
OK (
 )
Locking a Waveform Duration