Measurement Computing eZ-Analyst rev.14.1 - Manual (Page 49)

eZ-Analyst 978791 Edit Menu 4-13
Negative Averaging
Edit Menu > Configuration >
Input Channels Tab
The Input Channels tab displays the current setup conditions of the 8 Analog Input Channels
(CH1 through CH8) and the 4 Tachometer Channels (T1, T2, T3, and T4) on a channel-by-
channel basis. It also provides a means of changing the input channel settings. These
changes are accepted as soon as the or button is clicked.
Note: Output channel configuration is discussed on page 4-13.
When using WaveBook hardware, eZ-Analyst supports up to 64 channels
of input. If your WaveBook’s hardware configuration has more than 64
channels, eZ-Analyst
will display an error message and enter the Playback
mode. If you wish to use Measurement mode you will have to reduce the
channel count by removing expansion modules.
To remove the expansion
modules you must physically disconnect them from the WaveBook system .
When using ZonicBook/618E hardware, eZ-Analyst supports up to 56
channels of input. If your ZonicBook/618E hardware configuration has
more than 56 channels, eZ-Analyst
will display an error message and
enter the Playback mode. If you wish to run in the Measurement mode
you will have to reduce the channel count by removing expansion modules
by
physically disconnecting them from the ZonicBook/618E system .