Measurement Computing eZ-Analyst rev.14.1 - Manual (Page 68)

4-32 Edit Menu 978791 eZ-Analyst
Understanding Total Measured Data
In this figure, the Start Recording’s PreAcq-Trigger data and the Stop Recording’s Delay data
are both saved as part of the total measured data.
Edit Menu > Configuration > Recording Setup Tab: Scheduled Recording Panel
The Scheduled Recording panel includes a checkbox to enable the “scheduled recording”
function. It also includes three text fields (see following figure). The panel provides a means
of setting time conditions for starting and stopping a recording. dT is the delay time in
seconds.
Scheduled Recording Panel
When using Scheduled Recording, you need to set up the recording options
for automatic file creation. This is done in the Recording Setup Tab’s “File
Name Options” panel, discussed below.
Edit Menu > Configuration > Recording Setup Tab: File Name Options
File Name Options Panel
When using the Scheduled Recording feature the following steps should be taken to ensure
that each file will be automatically named by the program.
From the File Name Options panel, at the upper left of the Recording Setup Tab, verify that
the following is true. Make changes if needed.
File Name Prompt – Not Checked
Measurement Prompt – Not Checked
Auto Increase – Checked
Date/Time – Select the “Date/Time” radio-button if you want the Filenames to
automatically increase by a Date/Time convention, otherwise select “Number.”
Number – Select the “Number” radio-button if you want the Filenames to
automatically increase by a numerical sequence (1, 2, 3, ….N) convention, otherwise
select “Date/Time.”