Gasboy Fuel Point PLUS Station - Manual (Page 98)

98 Fuel Point PLUS Station Equipment Manual
2. In the Name field, enter a name to identify the bus (.i.e. Master Wireless Gateway)
3. In the Frame drop-down, select Orpak
4. Select the TCP/IP radio button
5. In the IP field, enter the Master Wireless Gateway IP address. Default IP is 192.168.1.170. It can
be changed in Master Wireless Gateway Setup Site, see General Setup
6. In the Port field, enter port number (between 3000 and 4000). It must match the TCP/IP Port
defined in Master Wireless Gateway Setup Site, see Setting Group Communication
7. Click New . The new bus is added to the grid at the top of the dialog
8. Click Close
8.4. Setting the Master Wireless Gateway
1. Select the VIS (Vehicle Identification System) tab. The VIS dialog box appears (see Figure 8-5 ).
Figure 8-5 - VIS Dialog Box
2. In the Name field, enter a name to identify the unit
3. In the Bus drop-down, select the bus you've created before
4. In the Model drop-down, select Wireless Gateway
5. In the Address section, select the HEX radio button and then enter the RS-485 address of the
group (between 31 and 39). It must match the Group Address defined in Master Wireless
Gateway Setup Site, see Setting Group Communication
6. Click New . The new item is added to the grid at the top of the dialog
7. Click Close