Gasboy Fuel Point PLUS Station - Manual (Page 49)

Fuel Point PLUS Station Equipment Manual 49
CHAPTER 6 SETTING THE NETWORK
6.1. General
The following describes the setup of the Wireless Network.
You can easily set-up the Wireless Network using the Setup Site .This site also gives you full access to
all Fuel Point PLUS components in the forecourt: Wireless Gateway, µWNR and DataPass for setup,
remote software updates and remote maintenance tasks.
6.2. Basic Steps for Setting the Wireless Network
1. Install the Wireless Gateway units. See Installing the Wireless Gateway
2. Install the µWNR units. See Online Help
3. Set the Master Wireless Gateway. See Setting the Master Wireless Gateway
4. Set the Wireless Gateway units. See Setting the Wireless Gateway Units
5. Set the µWNR units. See Programming WNR Units
6. Verify that all network components are communicating properly. See Monitoring Station
Equipment
6.3. Connecting the PC to the Unit
After the Master Wireless Gateway and Wireless Gateway units have been connected, proceed to
connect your PC :
1. Connect your PC to the unit's RJ-45 connector using a LAN cable (see Figure 6-1 )
Figure 6-1 - Wireless Gateway LAN Connectors