Zilog EZ80F916 - Manual (Page 434)

UM014423-0607 Using the Command Processor
ZiLOG Developer Studio II
eZ80Acclaim! ® User Manual
414
Executing Flash Commands
Examples
The following are valid examples for a target with an eZ80F91 and external Flash mem-
ory:
FLASH Options INTMEM
Flash Options PBF Page-erase Flash memory
Flash Options SERIALADDRESS = "<address>" Serial number address
Flash Options SERIALNUMBER = "<Number in Hex>" Initial serial number value
Flash Options SERIALSIZE = <1-8> Number of bytes in serial number
Flash Options INCREMENT = "<Decimal value>" Increment value for serial number
Flash Options NIP No info page
Flash Options IP Info page
Flash READSERIAL Read the serial number
Flash READSERIAL REPEAT Read the serial number and repeat
Flash BURNSERIAL Program the serial number
Flash BURNSERIAL REPEAT Program the serial number and repeat
Flash ERASE Erase Flash memory
Flash ERASE REPEAT Erase Flash memory and repeat
Flash BURN Program Flash memory
Flash BURN REPEAT Program Flash memory and repeat
Flash BURNVERIFY Program and verify Flash memory
Flash BURNVERIFY REPEAT Program and verify Flash memory and repeat
Flash VERIFY Verify Flash memory
Flash VERIFY REPEAT Verify Flash memory and repeat
The Flash Loader dialog box and the Command Processor interface use the
same parameters. If an option is not specified with the Command Processor
interface, the current setting in the Flash Loader dialog box is used. If a
setting is changed in the Command Processor interface, the Flash Loader
dialog box settings are changed .