Zilog EZ80F916 User Manual
Page 112
UM014423-0607
Using the Integrated Development Environment
ZiLOG Developer Studio II
eZ80Acclaim!
®
User Manual
92
bols. If this check box is deselected, the linker proceeds with generating output files even
if there are undefined symbols.
NOTE: Selecting this check box displays any “undefined external symbol” warning as an
error, regardless of the state of the Show Warnings check box in the General page
(see “Show Warnings” on page 58).
Warn on Segment Overlap
This check box enables or disables warnings when overlap occurs while binding seg-
ments. By default, the check box is selected, which is the recommended setting for
eZ80Acclaim!. For some ZiLOG processors, benign segment overlaps can occur, but, for
the eZ80Acclaim!, an overlap condition usually indicates an error in project configuration
that must be corrected. These errors in eZ80Acclaim! can be caused either by user assem-
bly code that erroneously assigns two or more segments to overlapping address ranges or
by user code defining the same interrupt vector segment in two or more places.
Project Settings—Output Page
The following figure shows the Output page.