Zilog EZ80F916 - Manual (Page 116)

UM014423-0607 Using the Integrated Development Environment
ZiLOG Developer Studio II
eZ80Acclaim! ® User Manual
96
Use Page Erase Before Flashing
Select the Use Page Erase Before Flashing check box to configure the internal Flash mem-
ory of the target hardware to be page-erased. If this check box is not selected, the internal
Flash is configured to be mass-erased.
Target
Select the appropriate target from the Target list box.
Setup
Click Setup in the Target area to display the Configure Target dialog box.
Figure 64. Configure Target Dialog Box
NOTE: The options displayed in the Configure Target dialog box depend on the CPU you selected
in the New Project dialog box (see “New Project” on page 39) or the General page of the
Project Settings dialog box (see “Project Settings—General Page” on page 57). Chip select
and external bus interface settings are only available for CPUs that support an external bus.