Altera Arria V Avalon-MM - Manual (Page 47)

Signal Direction Description
rx_st_bar[7:0] Output The decoded BAR bits for the TLP. Valid for
MRd
,
MWr
,
IOWR
, and
IORD
TLPs. Ignored for the completion or message TLPs. Valid
during the cycle in which
rx_st_sop
is asserted.
The following encodings are defined for Endpoints:
• Bit 0: BAR 0
• Bit 1: BAR 1
• Bit 2: Bar 2
• Bit 3: Bar 3
• Bit 4: Bar 4
• Bit 5: Bar 5
• Bit 6: Reserved
• Bit 7: Reserved
The following encodings are defined for Root Ports:
• Bit 0: BAR 0
• Bit 1: BAR 1
• Bit 2: Primary Bus number
• Bit 3: Secondary Bus number
• Bit 4: Secondary Bus number to Subordinate Bus number
window
• Bit 5: I/O window
• Bit 6: Non-Prefetchable window
• Bit 7: Prefetchable window
rx_st_data[-1:0] Output Receive data bus. Note that the position of the first payload
dword depends on whether the TLP address is qword aligned.
The mapping of message TLPs is the same as the mapping of
TLPs with 4-dword headers.
rx_st_eop
Output Indicates that this is the last cycle of the TLP when
rx_st_valid
is asserted.
rx_st_err Output Indicates that there is an ECC error in the internal RX buffer.
Active when ECC is enabled. ECC is automatically enabled by the
Quartus II assembler. ECC corrects single-bit errors and detects
double-bit errors on a per byte basis.
When an uncorrectable ECC error is detected,
rx_st_err
is
asserted for at least 1 cycle while
rx_st_valid
is asserted.
Altera recommends resetting the Arria V Hard IP for PCI
Express when an uncorrectable double-bit ECC error is detected.
UG-01105_avmm
2014.12.15
Hard IP Status Extension 4-17
Interfaces and Signal Descriptions Altera Corporation
Send Feedback