Altera Arria V Avalon-MM - Manual (Page 119)

Related Information
• 64- or 128-Bit Avalon-MM Interface to the Application Layer on page 4-1
• Avalon Interface Specifications
Clocks and Reset
The PCI Express Base Specification requires an input reference clock, which is called
refclk
in this design.
The PCI Express Base Specification stipulates that the frequency of this clock be 100 MHz.
The PCI Express Base Specification also requires a system configuration time of 100 ms. To meet this
specification, IP core includes an embedded hard reset controller. This reset controller exits the reset state
after the I/O ring of the device is initialized.
Transceiver Reconfiguration
The transceiver reconfiguration interface allows you to dynamically reconfigure the values of analog
settings in the PMA block of the transceiver. Dynamic reconfiguration is necessary to compensate for
process variations.
Related Information
Transceiver PHY IP Reconfiguration on page 12-1
Interrupts
The Hard IP for PCI Express offers the following interrupt mechanisms:
• Message Signaled Interrupts (MSI)— MSI uses the Transaction Layer's request-acknowledge
handshaking protocol to implement interrupts. The MSI Capability structure is stored in the Configu‐
ration Space and is programmable using Configuration Space accesses.
• MSI-X—The Transaction Layer generates MSI-X messages which are single dword memory writes. In
contrast to the MSI capability structure, which contains all of the control and status information for
the interrupt vectors, the MSI-X Capability structure points to an MSI-X table structure and MSI-X
PBA structure which are stored in memory.
Related Information
Interrupts for Endpoints when Multiple MSI/MSI-X Support Is Enabled on page 4-13
PIPE
The PIPE interface implements the Intel-designed PIPE interface specification. You can use this parallel
interface to speed simulation; however, you cannot use the PIPE interface in actual hardware.
• The Gen1, Gen2, and Gen3 simulation models support PIPE and serial simulation.
• For Gen3, the Altera BFM bypasses Gen3 Phase 2 and Phase 3 Equalization. However, Gen3 variants
can perform Phase 2 and Phase 3 equalization if instructed by a third-party BFM.
UG-01105_avmm
2014.12.15
Clocks and Reset 9-3
IP Core Architecture Altera Corporation
Send Feedback