Digilent 6003-410-000P-KIT - Manual (Page 86)

86 www.xilinx.com XUP Virtex-II Pro Development System
1-800-255-7778 UG069 (v1.0) March 8, 2005
Appendix B: Programming the Platform FLASH PROM User Area R
24. To load the newly programmed PROM configuration file into the Virtex-II Pro FPGA,
verify that the “CONFIG SOURCE” switch is set to enable high-speed SelectMap byte-
wide configuration from the on-board Platform Flash configuration PROM, and that
the “PROM VERSION” switch is set to enable the “User” configuration. If the switches
are set properly, only the green “PROM” LED (D19) is illuminated.
25. Press the “RESET\RELOAD” push button until the red “RELOAD” turns on. Release
the push button and the new “User” configuration is transferred to the FPGA.