Figure b-13 – Digilent 6003-410-000P-KIT User Manual
Page 84
84
XUP Virtex-II Pro Development System
1-800-255-7778
UG069 (v1.0) March 8, 2005
Appendix B: Programming the Platform FLASH PROM User Area
R
19. Right mouse click on the icon for the XCF32P PROM and select Program from the drop
down menu as shown in
20. The iMPACT software responds with a form that allows the user to specify which
design revisions are to be programmed and the programming options for the various
revisions. De-select Design Revision Rev 0 and all of the options for Design Revision
Rev 0 to minimize the programming time. Any options that you set for Design
Revision Rev 0 are ignored, because Design Revision Rev 0 has been previously
Erase/Write protected.
21. Select Design Revision Rev 1, and set the Erase (ER) bit to erase any previous “User”
design. Make sure that the Write Protect (WP) bit is not set.
22. Verify that the Operating Mode is set to Slave and the I/O Configuration is set to
Parallel Mode as shown in
.
Figure B-13:
Programming the PROM