Dell PowerVault 136T LTO/SDLT (Tape Library) - Manual (Page 66)

To choose one of the four selections, follow the step.
Step 1 Press the button beneath the desired softkey.
l
If the button beneath the Up softkey is pressed, the value of the current field is increased.
l If the button beneath the Down softkey is pressed, the value of the current field is decreased.
l If the button beneath the Next softkey is pressed, the next field in the list is made the active field. See Figure 101 .
l If the button beneath the Cancel softkey is pressed, the Picker Submenu is displayed.
Figure 101. Service > Library > Diags > Picker > Move > Use Axes Dialog
To choose one of the four selections, follow the step.
Step 2 Press the button beneath the desired softkey.
l If the button beneath the OK softkey is pressed, the values of the fields are accepted.
l
If the button beneath the Yes/No softkey is pressed, the value of the current field is toggled.
l If the button beneath the Next softkey is pressed, the next field in the list is made the active field. After reaching the end of the field list,
the active field reverts to the first field in the list.
l If the button beneath the Cancel softkey is pressed, the Picker Submenu is displayed.
Step Dialog
When Step is selected, the Step Dialog is displayed. See Figure 102 . This option is a collection of routines to manipulate the vertical and rotary
axes in incremental steps.
Figure 102. Service > Library > Diags > Picker > Step Dialog
To choose one of the two selections, follow the step.
Step 1 Press the button beneath the desired softkey.
l If the button beneath the OK softkey is pressed, Figure 103 appears. This is an advanced diagnostic tool that is not intended for use
Field Value Description
Cycles to run 0 .. 9999 The number of move cycles
Use vertical
Yes Move on the vertical axis
No Do not move on the vertical axis
Use horizontal
Yes Move on the horizontal axis
No Do not move on the horizontal axis
Field Value Description
Use vertical
Yes Move on the vertical axis
No Do not move on the vertical axis
Use horizontal
Yes Move on the horizontal axis
No Do not move on the horizontal axis