Dell PowerVault 136T LTO/SDLT (Tape Library) - Manual (Page 39)

Drive Log Dialog
When Drive Log is selected, the Select Drive Dialog is displayed. See Figure 27 . This option is used to view a running history log of error
conditions that have occurred. Refer to Diagnostics File Dialog to access the Drive Log Report via the RMU.
Figure 27. Status > Logs > Drive Log > Select Drive Dialog
To choose one of the three selections, follow the step.
Step 1 Press the button beneath the desired softkey.
l If the button beneath the OK softkey is pressed, the drive parameter is accepted and the Drive Log Dialog is displayed. Refer to Figure
28 .
l If the button beneath the Change Drive softkey is pressed, the Drive field is increased.
l
If the button beneath the Cancel softkey is pressed, the Logs Submenu is displayed.
Figure 28. Status > Logs > Drive Log Dialog
Command Menu Selection
The Command Menu is primarily used to manipulate the library at a motion command level. Command is selected from the Main Menu by following
this procedure.
NOTE: Commands listed under the Command Menu Selection require an offline state. Refer to Using Commands That Require an
Offline State for more information.
Step 1 Press the button beneath the Command softkey from the Main Menu.
The Command Menu appears. This menu offers four selections. See Figure 29 .
Figure 29. Main Menu > Command Menu
To choose one of the four selections, follow the step.
Step 2 Press the button beneath the desired softkey.
Field Value Description
Drive 01 .. 06 Drive number of log to be viewed