Dell POWEREDGE M1000E - Manual (Page 238)

210 Web Tools Administrator’s Guide
53-1002756-01
CUP logical path configuration
16
3. Click Copy.
The Allow / Prohibit Matrix Configuration dialog box displays.
4. In the dialog box, enter a name and description for the new configuration and click OK to save
the configuration to the target file; click Cancel to cancel copying the configuration.
The file name must be in alphanumeric characters and can contain only dashes or
underscores as special characters.
Deleting an Allow / Prohibit Matrix configuration
To delete a saved Allow / Prohibit Matrix configuration.
1. Display the Allow / Prohibit Matrix configuration list.
2. Select the saved configuration from the list.
3. Click Delete.
The Delete Allow / Prohibit Matrix Configuration confirmation dialog box displays.
4. Click Yes to delete the selected configuration; click No to cancel the deletion.
CUP logical path configuration
The logical reporting path is a CUP mechanism for sending FRU-failure type reports to a FICON
Logical Path via the FICON Protocol.
Viewing CUP logical path configurations
To display a list of CUP logical path configurations, perform the following steps.
1. Select a FICON-enabled switch from the Fabric Tree.
2. Select Configure > Switch Admin.
3. Click Show Advanced Mode to see all the available tabs and options.
4. Select the FICON CUP tab.
The FICON CUP page displays the FICON Management Server page in front. All attributes on
this page are read-only until FMS mode is enabled.
5. Click the CUP Logical Paths subtab.
Configuring CUP logical paths
To configure a CUP logical path, perform the following steps.
1. Select a FICON-enabled switch from the Fabric Tree.
2. Select Configure > Switch Admin.
3. Click Show Advanced Mode to see all the available tabs and options.
4. Select the FICON CUP tab.