Dell POWEREDGE M1000E - Manual (Page 123)

Web Tools Administrator’s Guide 95
53-1002756-01
Customizing basic monitoring graphs
7
NOTE
For the Brocade 300, 5100, 5300, 6510, 6520, VA-40FC, 7800 Extension, 8000, and the
Encryption Switch, enter only a port number.
4. Click OK.
The graph is displayed in a window in the Performance Monitor window.
Customizing basic monitoring graphs
You can customize some of the basic performance monitoring graphs to display information for
particular ports. For the Brocade 8510-8, Brocade 8510-4, and Brocade DCX and DCX-4S
enterprise-class platforms, you can also customize these graphs to display information for a slot.
You can customize the following graphs:
• Switch Throughput Utilization
• Switch Percent Utilization
• Port Snapshot Error
The following procedure assumes that you already created one of these customizable graphs.
1. Create or access the graph you want to customize.
Refer to “Creating basic performance monitor graphs” on page 94 for instructions on creating
a graph.
2. For Brocade 8510-8, Brocade 8510-4, and Brocade DCX and DCX-4S enterprise-class
platforms, display the detailed port throughput utilization rates for each port in a slot by
clicking the arrows next to a slot. The port information for that slot displays in the graph.
NOTE
For the Brocade 300, 5100, 5300, 6510, 6520, VA-40FC, 7800 Extension, 8000, and the
Encryption Switch, proceed to
step 3 .
3. To display detailed port throughput utilization rates for particular ports only, right-click
anywhere in the graph and click Select Ports.
The setup dialog box displays, as shown in Figure 23 .
The title of the dialog box varies, depending on the type of graph you are customizing, but the
layout of the dialog box is the same.
Figure 23 displays an example of the setup dialog box for
the Edit Switch Throughput Utilization graph.