Dell POWEREDGE M1000E - Manual (Page 175)

Web Tools Administrator’s Guide 147
53-1002756-01
Access Gateway policy modification
11
NOTE
When port configuration is in auto mode, the Configure N port groups, Configure F-N port mapping,
and Configure WWN-N port mapping buttons are disabled.
To enable auto rebalancing from the Switch Administration window, perform the following steps.
1. Click a port in the Switch View to open the Port Admin tab.
2. Select Automatic from the Port Configuration Policy drop-down list.
NOTE
When Port Configuration Policy is set to Advanced, you can enable the auto rebalancing
options from the Configure N_Port Groups dialog box through the Port Admin tab.
3. Click Yes in the confirmation window.
4. In the Switch Explorer window, click Configure > Switch Admin. The Switch Administration
window displays ( Figure 34 ).
FIGURE 34 Access Gateway Auto Rebalancing
5. Click Refresh.
6. Under the Access Gateway Mode section, do the following:
• Select the N Port Auto Rebalancing check box to enable N_Port rebalancing.
• Select F Port Auto Rebalancing check box to enable F_Port rebalancing.