Dell PowerEdge C8000 - Manual (Page 65)

Using the System Setup Program 65
5 In the Server screen, select Remote Access Configuration and press
.
6 In the Remote Access Configuration screen, verify the following settings:
• Remote Access: Enabled
• Serial port number: COM2
• Serial Port Mode: 115200 8,n,1
• Flow Control: None
• Redirection After BIOS POST: Always
• Terminal Type: ANSI
See "Remote Access Configuration" on page 106 for details. Make sure the
last four options syncs with the host and client.
7 In the Server screen, select BMC LAN Configuration and press .
8 In the BMC LAN Configuration screen, verify the following settings:
• BMC LAN Port Configuration: Shared-NIC
• BMC NIC IP Source: DHCP or Static (Use DHCP if your network
servers are using automatic assignment of IP addresses)
• IP Address: 192.168.001.003
• Subnet Mask: 255.255.255.000
• Gateway Address: 000.000.000.000
See "Set BMC LAN Configuration" on page 104 for details. Make sure the
host and client are on the same network
9 Press to return to the System Setup screen. Press again,
and a message prompts you to save the changes.