Dell PowerEdge C8000 User Manual
Page 252
252
Installing System Components
2 Install the back NVIDIA Tesla K20 GPGPU card.
CAUTION:
If you are installing a new NVIDIA Tesla K20 GPGPU card, ensure that
the back GPGPU card riser is installed on the sled cover with the proper screw
holes. If the GPGPU card riser is not installed with the correct screw holes, the
GPGPU card will not seat properly into the riser connector. Be sure the card riser
is installed through the "type B" screw holes. See "Installing the Back GPGPU Card
Riser" on page 271 for the location of the screw holes.
a
Align the mounting brackets with the screw holes on the back GPGPU
card. See Figure 3-76.
b
Replace the four screws securing the two mounting brackets.
c
Connect the emergency throttling cable to the back GPGPU card.
See Figure 3-75 or Figure 3-71 cable routing diagram.
d
Connect the power cables to the back GPGPU card. Press down on the
locking tab to secure the power cables. See Figure 3-75 or Figure 3-71
cable routing diagram.
e
Route the cables along the inside wall of the sled cover and secure the
cables to the retaining clips.
f
Holding the back GPGPU card assembly, position the card so that the
card edge connector aligns with the back GPGPU card riser connector
on the sled cover. See Figure 3-74.
g
Insert the card edge connector firmly into the riser connector until the
card is fully seated. See Figure 3-74.
h
Replace the four screws securing the back GPGPU card assembly to
the sled cover. See Figure 3-74.
i
Place the air baffle into the sled cover aligning the holes on the air
baffle with the screw holes on the sled cover. See Figure 3-73.
j
Replace the two screws securing the air baffle to the sled cover.
3 Lower the top cover to the sled cover and replace the five screws securing
the top cover to the sled cover. See Figure 3-67.
NOTE:
Be careful not to damage the twin axial cable on the back GPGPU card riser
when replacing the top cover. See Figure 3-67.
4 Close the sled. See "Installing the Sled Cover" on page 184.
5 Replace the sled. See "Installing a Sled" on page 156.