Dell PowerEdge C8000 - Manual (Page 125)

Using the System Setup Program 125
480B C6 State Enables the processor C6 state. (default)
480C L3 Cache Power
Control
Disable the clock stop for an idle subcache.
480D L3 Cache Power
Control
Enable the clock stop for an idle subcache.
480E C7 State Disables the processor C7 state. Do at your own risk.
480F C7 State Enables the processor C7 state. (default)
4810 Non Coherent
HT Link Width
Sets the HT link to 8 bit width.
4811 Non Coherent
HT Link Width
Sets the HT link to 16 bit width.
4812 Non Coherent
HT Link Speed
Sets the HT link speed to 800MHz.
4813 Non Coherent
HT Link Speed
Sets the HT link speed to 1000MHz.
4814 Non Coherent
HT Link Speed
Sets the HT link speed to 1200MHz.
4815 Non Coherent
HT Link Speed
Sets the HT link speed to 1600MHz.
4816 Non Coherent
HT Link Speed
Sets the HT link speed to 2000MHz.
4817 Non Coherent
HT Link Speed
Sets the HT link speed to 2600MHz.
4820 Memory Turbo
Mode
Disables memory turbo mode.
4821 Memory Turbo
Mode
Enables memory turbo mode.
4822 NUMA Support Enables the node interleave option for SLES11. This
applies to NUMA systems that allow memory
interleaving across all processor nodes.
Table 2-1. D4 Token Table (continued)
Token Setup Option Description