Dell PowerEdge C8000 - Manual (Page 265)

Installing System Components 265
1 Install the front Xeon Phi 5110P/7120P card.
a Remove the four screws securing the card bracket and lift the bracket
from the new card. Save the bracket for future use. See Figure 3-87.
Figure 3-87. Removing the Xeon Phi 5110P/7120P Card Bracket
b Align the mounting brackets with the screw holes on the front Xeon
Phi card. See Figure 3-82.
c Replace the four screws securing the two mounting brackets.
See Figure 3-82.
d Connect the power cables to the front Xeon Phi card. Press down on
the locking tab to secure the power cables. See Figure 3-80 or
Figure 3-81 cable routing diagram.
e Holding the front Xeon Phi card assembly, position the card so that
the card edge connector aligns with the front GPGPU card riser
connector on the sled cover. See Figure 3-79.
f Insert the card edge connector firmly into the riser connector until the
card is fully seated. See Figure 3-79.
g Replace the four screws securing the front card assembly to the sled
cover. See Figure 3-79.
1 screws (4) 2 card bracket
3 Xeon Phi 5110P/7120P card
1
2
3