Dell PowerEdge C8000 - Manual (Page 129)

Using the System Setup Program 129
4859 NIC
Enumeration
Sets PXE boot from onboard NIC to Add-on NIC
adapter. (default)
485A NIC
Enumeration
Sets PXE boot from Add-on NIC adapter to onboard
NIC.
485B PCIe Generation Sets the PCI signaling rate at Gen3 8.0 Gigabits
bandwidth.
485C PCIe Generation Sets the PCI signaling rate at Gen2 5.0 Gigabits
bandwidth.
485D PCIe Generation Sets the PCI signaling rate at Gen1 2.5 Gigabits
bandwidth.
485E Reboot on WOL
(ROW)
Disables ROW. (default)
The ROW repurposes the Wake on LAN (WOL)
signal to reboot the system board when the system is
in S0/S3 state.
485F Reboot on WOL
(ROW)
Enables ROW.
ROW repurposes the WOL signal to reboot the
system board when the system is in S0/S3 state. When
a WOL packet is received by the NIC, the wake up
signal generated by the NIC shall cause a hardware
reboot of the system board.
4860 USB PORT with
BMC
Allows you to electrically disable the internal USB port
which contacts to BMC.
4861 USB PORT with
BMC
Allow the users to electrically enable the internal USB
port which contacts to BMC.
4870 Force PXE Boot
only
Disables PXE to be the boot device only.
4871 Force PXE Boot
only
Enables PXE to be the boot device only. The system
retrying to boot from PXE device.
4873 Active Processor
Cores
This field controls the number of enabled 16 cores in
each processor. By default, the maximum number of
cores per processor will be enabled.
4877 PCIe Slot1 Allows you to electrically disable PCIe Slot1.
Table 2-1. D4 Token Table (continued)
Token Setup Option Description