Dell PowerEdge C8000 - Manual (Page 307)

Installing System Components 307
2 Replace the three screws securing the 10 GbE mezzanine card to the
bracket. See Figure 3-113.
3 Install the mezzanine card bridge board into the mezzanine slot on the
10 GbE mezzanine card. See Figure 3-112.
4 Replace the screw securing the mezzanine card bridge board to the
bracket. See Figure 3-112.
5 Lower the 10 GbE mezzanine card assembly to the sled tray.
See Figure 3-111.
6 Replace the two screws securing the 10 GbE mezzanine card assembly to
the sled tray. See Figure 3-111.
7 Close the sled. See "Installing the Front and Back Sled Covers" on
page 180 or "Installing the Sled Cover" on page 184.
8 Replace the sled. See "Installing a Sled" on page 156.
MicroSD Card Reader
Removing the MicroSD Card Reader
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on
page 176 or "Removing the Sled Cover" on page 181.
3 If applicable, remove the RAID battery. See "Removing the MegaRAID
SAS 9285CV-8e RAID Battery" on page 205.
4 If applicable, remove the mezzanine card. See "Removing the SAS
Mezzanine Card" on page 293, "Removing the Infiniband Mezzanine
Card" on page 300, or "Removing the 10 GbE Mezzanine Card" on
page 304.