Dell PowerEdge C8000 - Manual (Page 337)

Troubleshooting 337
If the problem is not resolved, proceed to the next step to begin
troubleshooting the other USB devices attached to the system.
5 Power down all attached USB devices and disconnect them from the
system.
6 Restart the sled and, if your keyboard is functioning, enter the system
setup program. Verify that all USB ports are enabled. See "USB
Configuration" on page 98.
If your keyboard is not functioning, you can also use remote access. If the
system is not accessible, see "System Board Jumper Settings" on page 358
for instructions on setting the NVRAM Clear jumper inside your system
and restoring the BIOS to the default settings.
7 Reconnect and power on each USB device one at a time.
8 If a device causes the same problem, power down the device, replace the
USB cable, and power up the device.
If the problem persists, replace the device.
If all troubleshooting fails, see "Getting Help" on page 377.
Troubleshooting a Serial I/O Device
1 Turn off the sled and any peripheral devices connected to the serial port.
2 Swap the serial interface cable with another working cable, and turn on the
sled and the serial device.
If the problem is resolved, replace the interface cable.
3 Turn off the sled and the serial device, and swap the device with a
comparable device.
4 Turn on the sled and the serial device.
If the problem is resolved, replace the serial device.
If the problem persists, see "Getting Help" on page 377.