Dell PowerEdge C8000 - Manual (Page 326)

326 Installing System Components
2 Open the sled. See "Removing the Front and Back Sled Covers" on
page 176 or "Removing the Sled Cover" on page 181.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 278.
4 Remove the heat sink. See "Removing a Heat Sink" on page 280.
5 Remove the processor. See "Removing a Processor" on page 285.
6 Remove the memory modules. See "Removing Memory Modules" on
page 291.
7 If installed, remove the expansion card or RAID controller card. See
"Removing the MegaRAID SAS 9265-8i RAID Controller Card" on
page 194 or "Removing the MegaRAID SAS 9285CV-8e RAID Controller
Card" on page 200.
8 If installed, remove the mezzanine card. See "Removing the SAS
Mezzanine Card" on page 293, "Removing the Infiniband Mezzanine
Card" on page 300, or "Removing the 10 GbE Mezzanine Card" on
page 304.
9 Remove the MicroSD card reader. See "Removing the MicroSD Card
Reader" on page 307.
10 Remove the MicroSD card reader support bracket. See "Removing the
MicroSD Card Reader Support Bracket" on page 310.
11 Remove the rear hard-drives. See "Removing a Hard-Drive Carrier Located
on the Sled Tray" on page 169.
12 Remove the hard-drive tray. See "Removing the Hard-Drive Tray" on
page 172.
13 Remove the interposer extender. See "Removing the Interposer Extender"
on page 313.
14 If applicable, remove the BMC management cable. See "Removing the
BMC Management Cable" on page 315.
15 Remove the node power distribution board. See "Removing the Node
Power Distribution Board" on page 317.