Dell PowerEdge C8000 - Manual (Page 321)

Installing System Components 321
Figure 3-120. Removing and Installing the Node Power Distribution Board
8 Disconnect all cables from the NPDB. See Figure 3-121. When you
disconnect the power cable, press down the cable-locking tab and
disconnect the power cable from the NPDB.
Note the routing of the cable underneath the tabs on the sled as you
remove them from the cover. You must route these cables properly when
you replace them to prevent the cables from being pinched or crimped.
9 Remove the four screws securing the NPDB to the NPDB assembly. See
Figure 3-121.
10 If necessary, press the retaining clip outward to unlock the node power
distribution board.
11 Lift the NPDB out of the NPDB assembly. See Figure 3-121.
1 NPDB assembly 2 M3 screws (2)
2
1