Dell PowerEdge C8000 - Manual (Page 322)

322 Installing System Components
Figure 3-121. Removing and Installing the Node Power Distribution Board
Installing the Node Power Distribution Board on the Sled Cover
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Insert the NPDB into the right retaining clip at a 45-degree angle, and
then press the other end of the board down into the left retaining clip to
secure the board in place. Make sure to align the NPDB with the screw
holes on the bracket. See Figure 3-121.
2 Replace the four screws securing the NPDB to the NPDB assembly. See
Figure 3-121.
1 M3 screws (4) 2 emergency throttling cable
3 power cable 4 power cable
5 power cable 6 node power distribution board
7 power cable 8 power cable
9 power cable
2
5
7
8
9
1
6
3 4