Installing the raid battery holder, Expansion card riser, Removing the expansion card riser – Dell PowerEdge C8000 User Manual
Page 209
Installing System Components
209
Installing the RAID Battery Holder
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Align the mounting board with the screw holes on the bracket.
2 Replace the three screws securing the mounting board to the bracket.
3 Align the battery holder with the screw holes on the mounting board.
4 Replace the three screws and three hex nuts securing the battery holder to
the mounting board. See Figure 3-44.
5 Replace the RAID battery. See "Installing the MegaRAID SAS 9285CV-8e
6 Close the sled. See "Installing the Front and Back Sled Covers" on
7 Replace the sled. See "Installing a Sled" on page 156.
Expansion Card Riser
Removing the Expansion Card Riser
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on