Installing the microsd card reader, Removing the microsd card reader support bracket, Removing the microsd card reader – Dell PowerEdge C8000 User Manual
Page 310: Support bracket
310
Installing System Components
Installing the MicroSD Card Reader
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Place the MicroSD card reader on the MicroSD card reader support
bracket. See Figure 3-115.
2 Replace the two screws securing the MicroSD card reader. See
3 Connect the MicroSD card reader cable to the MicroSD card reader.
4 If applicable, install the MicroSD card. Hold the MicroSD card with the
label side facing to the right and press the card into the slot to lock into
5 If applicable, replace the mezzanine card. See "Installing the SAS
Mezzanine Card" on page 299, "Installing the Infiniband Mezzanine Card"
on page 303, or "Installing the 10 GbE Mezzanine Card" on page 306.
6 If applicable, replace the RAID battery. See "Installing the MegaRAID SAS
9285CV-8e RAID Battery" on page 206.
7 Close the sled. See "Installing the Front and Back Sled Covers" on
page 180 or "Installing the Sled Cover" on page 184.
8 Replace the sled. See "Installing a Sled" on page 156.
Removing the MicroSD Card Reader Support Bracket
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Remove the sled from the enclosure. See "Removing a Sled" on page 155.
2 Open the sled. See "Removing the Front and Back Sled Covers" on