Great Plains YP625PD Predelivery Manual - Manual (Page 76)

72 Great Plains Manufacturing, Inc. Contents Index YP625PD/TD/925TD
401-754Q Contents Index 07/05/2011
Connect Fertilizer Hoses
Start at planter left, and connect a hose between one
meter port and coulter applicator at a time.
Refer to Figure 143
320. Select 9 or 12 of:
816-052C HOSE NATIVE GRASS SOLID STAND
and 18 or 24 of:
800-067C CLAMP BAND 2 1/2
321. Place a clamp on one end of a hose . Slide
the hose onto an outlet of a hopper meter. Secure
the clamp.
322. Place a clamp on the bottom end of the
hose . Slide the hose over the tube collar ,
until the hose end is flush with the bottom of the
collar. Center the clamp on the collar. Secure the
clamp.
Null4:
Install Pressure Gauge
Refer to Figure 144
The pressure gauge
is supplied largely
pre-assembled, and protected in bubble wrap. It is
installed right of center on the front tool bar.
The gauge must be located with between the center and
right fertilizer hoppers, or to the right of the right fertilizer
hopper (otherwise, it prevents the hopper from tilting
forward during clean-out).
323. Remove the bubble wrap and any loose
components. If the instruction sheet:
Bulletin A-27
Dwyer Magnehelic gauge instructions
is present, store it with the planter manuals.
324. Select one each:
403-692D PRESSURE GAUGE MOUNT
806-084C U-BOLT 5/8-11 X 7 1/32 X 9 1/2
and two sets:
804-022C WASHER LOCK SPRING 5/8 PLT
803-021C NUT HEX 5/8-11 PLT
Install the mount on the front tool bar, right of center,
and clear of hoppers. Tighten nuts
only to
Grade 2 torque, to avoid deforming the mount
tube
.
Null4:
Null4: .
Figure 143
Fertilizer Hoses
Q0098
362
244
134
362
244
244 362
244
362 134
Null4: .
Figure 144
Install Pressure Gauge
31862
201
341
402
313
287
402
405
201
341
313
287
287
201