Great Plains YP625PD Predelivery Manual - Manual (Page 51)

Great Plains Manufacturing, Inc. Contents Index Planter Assembly 47
07/05/2011 Contents Index 401-754Q
Route Speed Sensor Cables
Refer to Figure 94
A magnetic speed sensor
is pre-installed at the
output of the ground drive.
Refer to Figure 92
202. Select one:
833-452C DJ SENSOR TO RADAR 15.5 EXT.
Connect the WeatherPak end of the cable to
the lead from speed sensor . Route the cable
along the rear tool bar to implement center-line, and
then to the hitch.
Null4:
anchor-only
Null4:
Install Seed Harness
203. Based on planter model, select one of the harness
part number shown in the table at right. Refer to
harness diagrams on page 83 through page 95 for
illustrations of each harness.
204. Route the rear sections of the harness along the top
of the rear tool bar, with connector “ROW1” at the
left end of the tool bar.
205. Starting with the left-most row, route the row’s seed
sensor lead across the top of the opener mount.
Plug it into the harness lead for that row. Work
row-by-row, from left to right, so that connections
are made in order, and not skipped or crossed.
206. Select six (not shown):
800-244C CABLE TIE .19X15 PANDU BT4S-C0
Secure the seed harness and speed sensor to the
rear tool bar.
Null4:
Figure 94
Speed Sensor
Q0068
234
385
234
385
385
234
Null4:
Figure 95
Speed Sensor Cables
31860
234
385
Seed harnesses meet this general description:
• They have a central forward cable to the hitch, with
one or two circular connectors.
• The rear section of the harness has left and right cable
legs, with row sensor connectors spaced along them.
• The left leg of the rear cable has the sensor connector
labelled “ROW1”.
Planter Model Seed Harness
YP625PD18TP110 467981766
YP625TD12TR110 467981765
YP625TD18TP110 467981764
YP925TD0965 467981763
249