Great Plains YP625PD Predelivery Manual - Manual (Page 69)

Great Plains Manufacturing, Inc. Contents Index Planter Assembly 65
07/05/2011 Contents Index 401-754Q
Remove One Hopper U-bolt
Refer to Figure 130
289. At the left mount weldment
of the center dry
fertilizer hopper, remove two sets:
803-021C NUT HEX 5/8-11 PLT
804-022C WASHER LOCK SPRING 5/8 PLT
and one:
806-052C U-BOLT 5/8-11 X 7 1/32 X 8 1/2
These parts are not re-used.
Install Clamp
Refer to Figure 129 on page 64, Figure 130 and Figure 130
290. Select one each:
204-371D CLAMP PLT 7 CTR
and two sets:
802-269C HHCS 1/2-13X9 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
804-016C WASHER FLAT 1/2 SAE PLT
204-072D CLAMP SHANK 1 1/2 DIA
Place the lock washer , then the flat washer
on each bolt . Insert the bolts, from the rear, at
the weldment holes where the U-bolt was
removed in step 289. Add the clamp plate par-
tially assembled in step 288. at the front face of the
tool bar. Thread each bolt into the left side of a
shank clamp
. Leave loose for the moment.
291. Select one:
204-372D CLAMP PLT 7 SINGLE
and two sets:
802-289C HHCS 1/2-13X8 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
Place the lock washer on the bolt . Insert
the bolts through the holes in the single plate .
Place this assembly on the back side of the tool bar.
Thread the bolts into the threaded holes of the front
plate
. Tighten all bolts to torque specification.
Null4:
Null4: .
Figure 130
Remove Hopper U-bolt
31882
252
313
287
218
U
D
F
B
L
R
218
287
313
339
136
274
310
311
126
Null4: .
Figure 131
Center Coulter Mount, Front
Q0096
218
274
126
136
126
310 311
274
218 339
136
126
137
276
310
310 276
137
136